POLEPOX- POLYUREA SF
Fast-setting, rapid-curing, 100% solids, flexible, aromatic, two-component PURE spray polyurea that can be applied to suitably prepared concrete and metal surfaces. For a healthy application, the surface humidity should be below 5°C. It is fast curing with a touch-drying time of less than 30 seconds, 550% elongation, a flexible structure, and a Shore 50D hardness rating. It adheres tightly to the surface, eliminating contact with the external environment, preventing water/air permeability, and offering resistance to abrasion, vibration, and impact.
Recommended Use
- Oil and Natural Gas Piping Liner & Tanks.
- Airports and Refineries.
- Fertilizer Plants and Mining Operations.
- Food Processing Plants and Marine Environments.
- Secondary Containment.
- Water and Waste Water Treatment.
- Industrial and Manufacturing Facilities.
- Power Plants and Warehouse Floors.
- Cold Storage Facilities.
- Landfill Containment.
- Parking Garage Decks.
Features
- Zero VOC (100% Solids).
- Excellent Thermal Stability.
- Low Temperature Flexibility.
- Good Chemical Resistance.
- Coats Carbon or Mild Steel Metals without Primer.
- Seamless and Odorless.
Technical Data
PROPERTY VALUE / METHOD Mix Ratio By Volume 1A : 1B Pot Life @ 65.5°C 5 - 8 sec Tack Free Time (Thickness dependent) 45 - 60 sec Recoat Time 0 - 6 sec Density (Combined A & B) 1.05 - 1.10 Viscosity @ 66.5-71°C (Part A & B) 50 ± 10 cps Hardness (ASTM D-2240) SHORE A 85-90 / D 30-35 Tear Resistance (ASTM D-624) 55 - 60 Elongation (ASTM D-412) 550% ± 30% Water Vapor Permeability (ASTM E-96) 0.000360 perm-inch Service Temperature (Dry) -40°F to 250°F Service Temperature (Wet) -40°F to 120°F VOC Content 0 gm/lit Return to Service (Foot / Vehicle) 1-4 hours / >24 hours Recommended Applied Thickness > 2 mm Taber Abrasion Resistance (ASTM D4060) > 75 Water Absorption (ASTM D 471) < 0.5% loss Pull Off-Strength (Concrete) > 550 psi Lineal Shrinkage 1 - 2% Weather Test (QUV 3000 hrs) No cracking; color change observed
Application Procedure
Mixing: POLEPOX POLYUREA SF must not be diluted. Mix Part-A (Resin side) thoroughly with air-driven equipment until a homogeneous color is achieved.
Application: Precondition materials to 25°C. Surface temperature must be at least 3°C above the dew point. Apply using heated, high-pressure 1:1 spray equipment like Graco's Reactor. Both parts should be sprayed at minimum 2000 psi and temperatures above 66°C. Maintain adequate pressure and temperature at all times.
Packing & Storage
- Packaging: 420 KG SET (A: 200 KG, B: 220 KG).
- Shelf Life: One (1) year from manufacture in sealed containers.
- Storage: Store drums above 15°C. Use wooden pallets to avoid ground contact. Rotate drums regularly if stored long-term.
ATTENTION
-
-
-
-
For high-strength surfaces that combine aesthetics,
